February 2019 Taylormade4u Office Passport Kit Clipboard

Hello Friends,

Welcome back,

I have the most exciting design team project to share with you today! I was smitten from the moment my eyes landed on the beautiful Office Passport Kit from from Taylormade4u!

My mind began wandering and weaving together a visual project in my minds eye, I hoped to create, and I did.

Check it out......... using Taylormade4u, Office Passport Kit, found here:https://taylormadecards4u.blogspot.com/…/vintage-office-feb…

I used a smaller clip board, created a pocket for the bottom, which was very easy by measuring the height and width where you wanted your pocket to be, and the trimming the card stock, 2 pieces for the sides and 1 piece for the bottom, to size. Next create a series of valley and mountain folds, spaced 1 inch apart till you have 3 folds with tabs on each piece for the sides. Next cut out the front of the pocket, and then the bottom of the pocket 2 in wide by the length of you clip board, scoring in the middle at 1 inch and fold. Assemble your pocket by, gluing the sides and bottom together and then embellishing the front of the pocket. Next take care adhering  your pocket to the front of your clip board, which had been previously covered in the paper of your choice.

Next, begin making your embellishments which will be adhered to the inside of the pocket here and there to the folds. to give your project dimension. From there the sky is the limit!

Thank You for your interest, and your continued support, until next time....

Robin